|
Hole size is a positive number from 0.01" (0.25 mm) to 1" (25.4 mm) Check the drill sets that you own on the Settings page. |
|
|
- Anodized handwheels for apron and tailstock
- Chrome levers for half-nuts, tool post and tailstock
- Handwheels: 90 mm OD, 8 mm bore
- Levers: M8 threading
- Acron Nuts: M8 threading
|
|
- Works with 0XA tool post
- Makes threading easier and safer
- Made in the USA
|
|
- Milling machine chip shield uses strong Neodymium magnets to mount to the front or back of a machine
- Conveniently remove without the hassle of fussing with tools or screws
- Adjustable friction hinges allow setting the side panels at any angle up to 150 degrees
- Compatible with any 3"- 4" milling vise with a flat surface on either end
- Approximate dimensions: 11 1/4" x 3 3/4" x 1/4"
|
|
|
Band Saw, 4x6, Horizontal/Vertical, Rikon
